Asense CO2 Duct Sensor
Installation and Operation
#NSA-ASENSE-D-LCD-REL, NSA-ASENSE-D-REL
– 11/14/2019
Specifications subject to change without notice.
Catalog No. 11-808-745-01
Page
4
of
9
Mounting the sensor
The wall plate is screwed onto the wall
The screw head diameter should be
max 7,5 mm
The screw head height should be
max 2,5 mm
(A) Put the top tabs of the front part into the top holes of the wall plate.
(B) Press the lower edge of the case onto the wall plate to latch
The top part is pushed under the locking hooks of
the wall plate and secured with a screw.
Terminals and jumpers on aSENSE RL.
The darker positions are default settings.
Terminals and jumpers are located under the top part.
CAUTION
If the PCB must be removed, it must be handed carefully and protected from electrostatic discharge! Removing
the PCB is not normally required.
