Full DoC to 2014/53/EU (RED) can be download-
ed at www.cavius.com
WARNING: All alarms should be assumed as due
to actual fire and the dwelling should be evacuated
immediately.
WARNING: Batteries shall not be exposed to ex-
cessive heat such as shine, fire, or the like. Note
the local country regulations regarding installation.
The CE mark affixed to the product confirms
compliance with all relevant European directives
along with the Radio Equipment Directive (RED)
2014/53/EU for all wireless family products.
All Rights reserved: CAVIUS Aps assumes no
responsibility for any errors, which may appear in
this manual. Furthermore, CAVIUS Aps reserves
the right to alter the hard ware, software, and/or
specifications detailed herein at any time without
notice, and CAVIUS Aps does not make any com-
mitment to update the information contained here-
in. All the trademarks listed herein are owned by their
respective owners. Copyright © CAVIUS Aps.
Developed by CAVIUS Aps, Jens Juuls Vej 28 K,
DK- 8260. Manufactured in P.R.C.
127747rev2
5. HOW TO HUSH AN ALARM USING THE
SMART REMOTE:
When the alarms from the Wireless Alarm Family
go into alarm, they can be hushed by a short press
on the end button of the Smart Remote.
• During the first 30 seconds of an alarm: Press
the red end button once and the remote stops
sounding and vibrating, LED is still flashing. The
remote is now waiting to send out the hush signal
which will start automatically within 30 seconds.
• After 30 seconds of an alarm:
Press the red end button once and the remote
will send out a hush signal for 13 seconds.
If needed to hush several alarms, this can be
repeated as many times as necessary.
Please note: Due to coming legislation, the hush
signal is transmitted with reduced power (the re-
mote must be within short range from the silenced
alarm, which means you should be in the same
room as the alarm).
You can hush any of your alarms in the system,
as long as you are in in the same room and within
short range of the alarm.
You can go from room to room and hush the alarms
by short press till you find the originating alarm (the
one that flash), then check the cause of alarm.
All the others devices will be silenced too.
If you hush an alarm other than the source of the
alarm, the remaining alarms will still sound.
6. FLASHLIGHT:
The flashlight can be activated by pressing the side
button. By pressing again you turn off the light.
Please note: The light will go out automatically af-
ter 5 minutes.
7. LOW BATTERY SIGNAL:
When the battery is starting its end of life, a short
beep will sound out every 48 seconds for 30 days.
Only the device affected by the low battery will
beep, no other connected devices will sound.
It is safe to change batteries in the Smart Re-
mote without going through the learn process
again – it will not forget the codes during the battery
change process.
8. BATTERIES REPLACEMENT:
You can access the 3 x AAA batteries by removing
the end cap.
Replace the batteries respecting polarities. Always
test the Smart Remote after battery replacement.
Caution: There is a risk of explosion if the batter-
ies are replaced by an incorrect type.
9. MAINTENANCE & TROUBLESHOOTING:
If the Smart Remote does not work when the test/
hush button is pushed, the probable cause is
faulty batteries which must be replaced. Please
refer to troubleshooting at www.cavius.com.
10. HOW THE SMART REMOTE IS BEHAVING:
When the remote is:
Receiving a signal from an alarm:
- vibrating, sounding and LED is flashing
Waiting to send a hush signal during the first 30
seconds of an alarm:
- LED is flashing
Sending a hush signal:
- quick vibration, sounding and LED is flashing
for 13 seconds
Receiving a test signal:
- quick vibration and LED is flashing
11. OTHER INFORMATION:
Disposal: For battery and product, please dispose
properly at the end of life. This is electronic waste
which should be recycled.
Complies to the Radio Equipment Directive
2014/53/EU.
Interlinked by RF: 868 MHz.
Maximum radio-frequency power transmitted: 20
dBm.
