GB - 7
E N G L I S H
SPLIT
Preparation for:
heating
SPLIT
Preparation for:
dehumidification
SPLIT
Preparation for:
fan only
The dehumidification only function
should be used if you want to remove
moisture from the room air without
lowering the temperature.
Position both the indoor and outdoor
units in the room you want to
dehumidify (cellar, garage,
warehouse).
In the “fan only” function, the air is circulated in the room without
any temperature modification.
The outdoor unit can be positioned either inside or outside the
room.
To empty the tank, switch the unit off
and remove the plug from the power
supply socket.
Remove the outdoor unit if it is connected
to the indoor unit.
When heating, the outdoor unit can be placed either outside or
inside the room to be heated.
Take out the full water tank on the rear of
the unit and empty it.
Then replace it correctly in its position.
In certain applications a floor drain may
be provided and it may be easier to use
the drain tube to remove the condensate
water directly.
Proceed as follows:
• Pull out the 60 mm long condensate
drain tube and remove the plug.
• Connect the drain tube to the floor
drain using a rubber tube.
After use remember to put the plug
into the drain tube and to replace the
tube in its position.