background image

3

Fig. 1 — Heat Section Details

See Fig. 1 for location of gas valve(s). Refer to Fig. 2 while

proceeding with the following steps.
1. Turn off the unit demand for cooling or heating by using

the scrolling marquee. The scrolling marquee is located in
the control box at the compressor end of the unit.

 a. Push the 

 key until a blank display screen is

shown.

 b. Push the 

 key until the SERVICE TEST LED is lit.

 c. Push the 

 key. The display will show STOP.

 d. Push the 

 key again. The NO/YES display

will flash.

 e. Push  the 

 or 

 key to toggle the display to YES

and then push 

. The unit will be locked off

from heating, cooling or any operation. The controls

will still function and the display will still operate.

2. Close the field-installed manual gas shutoff valve.

3. Turn off the electrical power to the unit using the optional

disconnect or the field-installed disconnect and lock off

using proper lockout and tag-out procedures.

4. Open the burner section hinged access door.

5. Move the switch on the gas valves to the OFF position and

wait 5 minutes.

NOTE: If this is the first installation of the unit, the gas flue hoods

must be installed before operating unit. These must be installed for

the unit to run properly.
6. Move the switch on the gas valves to the ON position.

7. Close the burner section hinged access door.

8. Turn on the electrical supply to the units.
9. Open the field-installed manual gas valve.

LIMIT

S

WITCH

NO. 1

S

ECTION 1

S

ECTION 2

LIMIT

S

WITCH

NO. 2

GA

S

 VALVE

GA

S

 VALVE

FLUE
OUTLET

FLUE
OUTLET

NOTE: High heat consists of sections 1 and 2. Low heat consists
of section 1 only.

030-050 SIZES

GA

S

 VALVE

FLUE
OUTLET

LIMIT

S

WITCH

NO. 1

S

ECTION 1

S

ECTION 2

LIMIT

S

WITCH

NO. 2

FLUE
OUTLET

GA

S

 VALVE

GA

S

 VALVE

FLUE
OUTLET

LIMIT

S

WITCH

NO. 1

S

ECTION 1

LIMIT

S

WITCH

NO. 2

S

ECTION 2

FLUE
OUTLET

GA

S

 VALVE

S

ECTION 

3

FLUE
OUTLET

GA

S

 VALVE

NOTE: High heat consists of sections 1-3. Low heat consists of
sections 1 and 2 only.

055-100 SIZES HIGH HEAT

NOTE: High heat consists of sections 1-3. Low heat consists of
sections 1 and 2 only.

055-100 SIZES LOW HEAT

ESCAPE

ENTER

ENTER

ENTER

Содержание 48P 030









Отзывы: