Electrical Data
UNIT
SIZE-SERIES
V/PH
OPER VOLTS*
COMPRESSOR
FAN
FLA
MCA
60°C
MIN
WIRE
SIZE†
75°C
MIN
WIRE
SIZE†
60°C
MAX
LENGTH
(FT)‡
75°C
MAX
LENGTH
(FT)‡
MAX FUSE**
OR
CKT BKR
AMPS
Max
Min
LRA
RLA
024-30
208/230/1
253
187
61.0
15.1
0.8
19.7
14
14
39
37
30
030-30
72.5
14.7
1.1
19.5
14
14
39
37
30
036-30
83.0
15.4
1.1
20.4
12
12
60
57
30
042-30
104.0
21.1
1.1
27.5
10
10
71
68
40
048-30
109.0
20.5
1.4
27.0
10
10
74
70
40
060-31
158.0
27.6
1.4
35.9
8
8
86
82
60
* Permissible limits of the voltage range at which unit will operate satisfactorily. Operation outside these limits may result in unit failure.
† If other than uncoated (non-plated), 60° or 75°C (140° or 167°F) insulation, copper wire (solid wire for 10 AWG and smaller, stranded wire for larger than 10 AWG)
is used, consult applicable tables of the NEC (ANSI/NFPA 70).
If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70). The ampacity of nonmetallic-sheathed cable (NM), trade name
ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article 336-30.
‡ Length shown is as measured 1 way along the wire path between the unit and the service panel for a voltage drop not to exceed 2 percent.
** Time-delay fuse.
FLA—Full Load Amps
LRA—Locked Rotor Amps
MCA—Minimum Circuit Amp
RLA—Rated Load Amps
NOTE: 1. Control circuit is 24v on all units and requires external power source.
2. Copper wire must be used from service disconnect to unit.
3. All motors/compressors contain internal overload protection.
Tested Combination Ratings*
UNIT SIZE-
SERIES
INDOOR
UNIT
ARI STANDARD RATINGS†
Cooling
Heating
TC
SEER
EER
High-Temp
Low-Temp
HSPF
Factory-
Supplied
Enhance-
ment
Standard
Rating
Carrier
Gas
Furnace
or
Accessory
TDR‡
Accessory
TXV**
TC
COP
TC
COP
024-30
FX4ANF030
25,000
TDR & TXV
13.00
—
—
11.50
25,000
3.30
16,600
2.30
8.00
030-30
FX4ANF030
29,000
TDR & TXV
13.00
—
—
11.40
30,000
3.50
18,500
2.34
8.00
036-30
FX4ANF042
35,000
TDR & TXV
13.00
—
—
11.30
35,000
3.35
21,600
2.34
7.70
042-30
FV4ANF003
40,500
TDR & TXV
13.10
—
—
11.30
40,500
3.35
25,400
2.45
7.70
048-30
FV4ANF005
45,500
TDR & TXV
13.50
—
—
12.00
47,500
3.50
28,300
2.50
8.50
060-31
FV4ANB006
58,500
TDR & TXV
13.20
—
—
11.00
60,000
3.50
37,000
2.53
8.00
* Outdoor section/indoor section combination tested in accordance with DOE test procedure for heat pumps.
† Ratings are net values reflecting the effects of circulating fan heat. Supplemental electric heat is not included. Ratings are based on:
Cooling Standard: 80°F (27°C) db 67°F (19°C) wb indoor entering air temperature and 95°F (35°C) db air entering outdoor unit.
High-Temp Heating Standard: 70°F (21°C) db indoor entering air temperature and 47°F (8°C) db 43°F (6°C) wb air entering outdoor unit.
Low-Temp Heating Standard: 70°F (21°C) db indoor entering air temperature and 17°F (-9°C) db 15°F (-10°C) wb air entering outdoor unit.
‡ In most cases, only 1 method should be used to achieve TDR function. Using more than 1 method in a system may cause degradation in performance. Use either
the accessory Time-Delay Relay KAATD0101TDR or a furnace equipped with TDR. All Carrier furnaces are equipped with TDR except for the 58GFA.
** Based on computer simulation. TXV must be R-410A compatible and hard shutoff type.
COP—Coefficient of Performance
EER—Energy Efficiency Ratio
HSPF—Heating Seasonal Performance Factor
SEER—Seasonal Energy Efficiency Ratio
TC—Total Capacity (Btuh)
TDR—Time-Delay Relay
TXV—Thermostatic Expansion Valve
Sound Rating (dBA)
UNIT SIZE-SERIES
SOUND RATING
024-30
70
030-30
72
036-30
74
042-30
73
048-30
76
060-31
76
4