Carrier TRANSICOLD VECTOR 8100, Руководство по эксплуатации и обслуживанию, Страница: 77 / 294

3–27 62-11785
3.19 OPTION - DATATRAK
DataTrak allows remote communication with the APX control system (cellular, satellite, etc).
One Way Communication providers can request data from the System and transmit it via their equipment to
another location. This is typically done via the Internet to any destination in the world.
WARNING
!
APX control system equipped units may start automatically at any time the START/RUN - OFF
switch is not in the OFF position. Also, the unit may be fitted with two way communication
equipment that will allow starting of the unit from a remote location even though the switch is
in the OFF position.
Two Way Communication providers can also send commands via their equipment to the control system to start or
stop the unit, change settings and the way the System is operating the unit.
DataTrak is factory installed. DataTrak installation can be confirmed by scrolling through the Advanced User Unit
Data (refer to
Section 3.14 ). DataTrak will be listed under the Installed Options heading.
The control system must be configured for the provider that will be connecting to it (refer to Section 5.2.3 ). The
Satellite Com Configuration can be set for “Qualcomm” or “Other”. If the provider is “Qualcomm” and the original
Qualcomm TrailerTracs system is being used then the “Qualcomm” selection must be made. If the provider is Qual-
comm and the newer TrailerTracs T2 system is being used or another communications provider is used, “Other”
should be selected.
Carrier Transicold has worked with approved communication providers with recommended installation locations,
and wiring connections to Carrier units. Instructions for installing this equipment is supplied by each individual pro-
vider, and not by Carrier Transicold. Communications electrical harnesses are available from Carrier Transicold
Performance Parts Group (PPG).