20
Adit 3104 - Release 1.6
Quick Start
Setting up a CLI Connection
Setting up a CLI Connection
A CLI connection will require the LAN or WAN IP address of the unit. Note: If the WAN IP address
is used, the remote admin WAN access must be enabled with the following command sequence:
NOTE:
For Adit 3104 CLI commands see the
Adit 3000 CLI Reference Manual.
This is a
separate document and can be found on the CD that is provided with the product, or on the
Carrier Access customer website.
To connect with CLI, set up the connection:
z
If connecting via the Ethernet 100Base-TX connection, use a Telnet TCP/IP program to access
the CLI. This requires an IP address of the unit.
Note: to display the current IP address of the unit, use the
ifconfig
command.
z
If connecting via RS-232, the port settings should be set to:
Bits per second:
115200
Data bits:
8
Parity:
None
Stop bits:
1
Flow control:
None
z
Set your Terminal Emulation to:
VT100
NOTE:
When using Tera Term (Telnet program) TCP/IP, CLI commands will not be
recognized until the following setup is completed.
z
In Tera Term go to
Setup/Terminal
z
Set the
New-line/Transmit
value
CR+LF
Command
Description
Username: admin
Password: ********
Log into the system (username and password).
Adit 3104> enable
Enter the Privileged mode.
Password: ********
Enter password for the Privileged mode.
#configure terminal
Enter the Configuration mode.
(config)# remote-admin web
primary-port enable
Enable remote web admin.
