background image

7

2

2

1

2

 

     

To  bond  the  second  controller,  press 

twice

  on  the  button  “Lane 

choice” 

1

. The right LED now lights continuously. Now press the 

“Bonding  button” 

2

  of  the  second  hand  controller.  If  bonding  is 

successful,  both  LEDs  will  then  light  continuously.  The  controller 

is now bonded to the connector track and controls the car on the 

rear lane. 

To display the address set for the speed controller, press once on 

the binding button 

1

 on the top of the speed controller.

The LED 

2

 will then flash, according to the address set.

1

2

Preparation of start

Before using them for the first time, the 2.4 GHz W hand 

controllers should be fully charged. To do this, put the controllers in 

the charger and switch on the track. While charging is in progress, 

the LED‘s 

1

 on the hand controllers will flash. When charging is 

complete, the LEDs 

1

 light continuously. By employing a lithium-

polymer battery, the hand controllers can be topped up at any time. 

1

1

If the speed controller is not actuated, it switches automatically after 

about 30 seconds into energy-saving mode. The speed controller 

can be reactivated by pressing the tappet or the lane-change button.

 

Troubleshooting

 

In case of any malfunctions, please check the following:

• Is the connector track properly connected in the running direction?

• Are the power pack plugs inserted the right way round?

• Is the battery fully charged?

• Does the LED on the controller flash while charging?

• Is the speed controller bound to the receiver?

• Is the hand controller bonded to the connector track?

• Has the speed controller got a duplicate address assignment?

• Is the connector track in stand-by mode?

Note:

During operation small car parts as spoilers or mirrors may get off or 

brake due to being original detailed parts of the car model. To avoid 

this it is possible to remove them before operation.

All Carrera spare parts are available in the webshop: 

carrera-toys.com

Delivery exclusively to Germany, Austria, Netherlands, Belgium and 

Luxembourg.

Maintenance and care

1

To ensure a proper operation of the motor-racing circuit, all race-

track components should be regularly cleaned. Pull the plug prior 

to cleaning.

1

 Racetrack:

 Keep the track surface and track slots clean with a 

dry cloth. Do not use any solvents or chemicals for cleaning. When 

it is not in use, store the racetrack in a clean and dust-protected 

location, preferably in the original cardboard box.

Technical specifications

Output voltage: Toy transformer

 

 

14,8 V  

  2 x 14,8 VA  (Carrera EVoLuTIoN)

 

lithium polymer rechargeable battery:  

 

3,7 

  150mAh · 0.55 Wh

 

Maximum charging time: 2 hours

Electricity modes:

1.) operating mode = cars are operated via speed controllers

2.)  Idle mode/Stand-by mode = speed controllers not activated,

  no game

  CuRRENT CoNSuMPTIoN < 0.5 watt/0.5W 

3.) Stand-by mode = after approx. 20 minutes idle mode the 

  connecting section switches to stand-by mode. 

  The LED is not lit any more.

  CuRRENT CoNSuMPTIoN < 0.5 watt/0.5W 

   By  switching  the  connection  track  off  and  then  on  again  

the  stand-by  modus  is  terminated  and  the  track  is  once 

again in ‘sleep’ mode.

4.) To switch off = power supply unit disconnected from mains supply

         

 

 

This device is marked by “selective sort throught” symbol related to 

sort through domestic, electric and electronic, waste. This means 

the product must be treated by a specialized “sorting/collecting” sys-

tem in accordance with European directive 2002/96/CE, to reduce 

the impact upon environment. For more precise information, please 

contact  your  local  administration.  Electronical  product  which  are 

not going through special collecting, are potentially dangerous for 

environment and human health,  because of dangerous substance.

Output voltage: Toy transformer

 

 

14,8 V  

  2 x 14,8 VA  (Carrera EVoLuTIoN)

 

lithium polymer rechargeable battery:  

 

3,7 

  150mAh · 0.55 Wh

 

Maximum charging time: 2 hours

Electricity modes:

1.) operating mode = cars are operated via speed controllers

2.)  Idle mode/Stand-by mode = speed controllers not activated,

  no game

  CuRRENT CoNSuMPTIoN < 0.5 watt/0,5W 

3.) Stand-by mode = after approx. 20 minutes idle mode the 

  connecting section switches to stand-by mode. 

  The LED is not lit any more.

  CuRRENT CoNSuMPTIoN < 0.5 watt/0.5W 

   By  switching  the  connection  track  off  and  then  on  again  

the  stand-by  modus  is  terminated  and  the  track  is  once 

again in ‘sleep’ mode.

4.) To switch off = power supply unit disconnected from mains supply

 

 

 

 

 

 

Requirement for FCC Part 15

Warning:  Changes  or  modifications  not  expressly  approved 

by the party responsible for compliance could void the user’s 

authority to operate the equipment.

Note: 

This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency en-

ergy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular 

installation.

If this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and receiver,

•  Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for 

help.

 

Warnings

Guidelines and warnings about using the LiPo battery/batteries:

LiPo rechargeable batteries are much more sensitive than the tradi-

tional alkaline or NiMh rechargeables. For this reason all instructions 

and warnings must be scrupulously observed. Incorrect treatment of 

LiPo rechargeable batteries may cause a fire. In handling, charging 

and using the LiPo battery/batteries supplied, you take over all re-

sponsibility for the risks attached to lithium batteries.

• Non-rechargeable batteries must not be recharged!

For recharging batteries, only the charging cradle supplied may be 

used. If this instruction is disregarded, there is a risk of fire which may 

endanger your health and/or cause damage to property.

NEVER use any other charging unit!

• Rechargeable batteries may only be recharged under adult supervi-

sion. When charging, never leave the battery unattended.

When you recharge the battery, you should always be in the vicinity 

to keep watch on the process so that you can react to any possible 

problem.

• If the battery swells or deforms during either discharge or charging 

process, stop the process immediately. Remove the battery as fast 

and as carefully as possible and place it on a safe and open area 

away from any flammable materials, and keep it under observation for 

at least 15 minutes. If you continue to charge or discharge a battery 

which has already started to swell or deform, there is danger of fire! 

Even at the slightest sign of swelling or deforming, the battery must 

be taken out of service.

• The battery supplied must be charged in a safe place away from 

flammable materials.  

• Store the battery at room temperature (16 - 18 °C) in a dry place.

Do not expose the battery to direct sunlight or any other sources of 

heat. Temperatures over 50 °C are generally to be avoided.

• Always recharge the battery after use to avoid the possibility of its 

becoming deep discharged. When it is not in use, recharge the bat-

tery from time to time, say every 2-3 months. Failure to observe the 

methods of handling described above may lead to defects.

• When changing batteries do not use any sharp or pointed objects 

or tools. Avoid damaging the protective foil around the battery at all 

costs.  

• When replacing defective batteries, only the recommended battery 

types may be used. Damaged or unusable batteries are hazardous 

waste, and must be disposed of accordingly.

• Never throw batteries, rechargeable or otherwise, on the fire or ex-

pose them to high temperatures. This may cause a fire or an explo-

sion.

• The electrolyte and electrolyte vapour in the LiPo batteries are haz-

ardous to health. Always avoid direct contact with electrolyte.

If electrolyte makes contact with skin, eyes or other parts of the body, 

it must immediately be washed out or off with plenty of fresh water and 

a doctor must be consulted.

• Rechargeable batteries are not toys and must not fall into the hands 

of children. Keep batteries inaccessible to children.

•  The  connector  clips  /  battery  connections  must  never  be  short-

circuited!

• The toy is only to be operated with a transformer or power pack 

designed for use with toys!

• The transformer / the power pack is not a toy!

Содержание Wireless+ 10115






Отзывы: