28
Menu items
Press down the standby/menu button for 3 seconds to enter the options menu.
1. Selecting the DMX-address:
Menuꢀitemꢀ“DMXADR”
:
-
Use
ꢀꢀ
the
ꢀꢀ
right encoder
ꢀꢀ
to
ꢀꢀ
select
ꢀꢀ
the desired start
ꢀꢀ
address
ꢀꢀ
(1-511).
-
Press the standby/menu button for 3 seconds (menu-mode).
-
By briefly pressing the standby/menu button again the set value is stored.
2. Selecting the DMX-mode
Menuꢀ itemꢀ “MODE”
: The control unit provides the modes 8-Bit exponential, 8-Bit
linear and 16-Bit linear:
-
Use
ꢀꢀ
the
ꢀꢀ
right encoder
ꢀꢀ
to
ꢀꢀ
select
ꢀꢀ
the desired mode.
-
By briefly pressing the standby/menu button the set value is stored.
Explanation of the DMX mode 16-Bit lin:
In the 16-Bit mode the device needs 3 DMX
channels for light control. The first two channels (start address and start a 1)
form a combined 16-Bit channel for the brightness adjustment. The third channel (start
2) is used for the 8-bit setting of the color temperature.
Please note,
whenꢀinꢀDMXꢀ“StandꢀAloneꢀ“use,ꢀorꢀwhenꢀtheꢀlampꢀisꢀtheꢀlastꢀin
the
ꢀꢀ
DMX
ꢀꢀ
chain,
ꢀꢀ
the
ꢀꢀ
use
ꢀꢀ
of
ꢀꢀ
a
ꢀꢀ
120
ꢀꢀΩ
ꢀꢀ
(Ohm)
ꢀꢀ
termination/load
ꢀꢀ
resistor
ꢀꢀ
could
ꢀꢀ
be
ꢀꢀ
necessary
ꢀꢀ
(not
included within the lamp kit).
3. Selecting the DMX-status:
Menuꢀitemꢀ„DMXꢀSTATUS“
: In this menu item you can activate or deactivate DMX:
-
Use
ꢀꢀ
the
ꢀꢀ
right encoder
ꢀꢀ
to
ꢀꢀ
select
ꢀꢀ
the desired status.
-
By briefly pressing the standby/menu button the set value is stored.
ATTENTION:
When switching off the device this value will always be overwritten by an
active
DMX!
4. Adjusting the display backlight:
Menu
itemꢀ“BACKLIGHT”
:
-
ꢀꢀ
Use
ꢀꢀ
the right encoder to adjust the brightness (
ꢀꢀ
0-100% in steps of 5).
-
By briefly pressing the standby/menu button the set value is stored.
5. Checking the firmware version:
This menu item will display the firmware version of the controller without any
adjustment options.
