7
Attention: Normally, Remote Control has been set OK before leaving Carp Royal, any damage caused to the
Remote Control by your improper using or blind setting is on your account.
Using Direction
Attention: Before you use the boat,
* We advise you keeping the shipping box of the boat in case you may return it for repairing.
* You must charge up your accumulators to full at first step before using.
* Please keep the full batteries of the R.C., otherwise, it will seriously influence the signal strength.
STEP 1. Set up Batteries
（
（
（
（
1
）
）
）
）
Set up Batteries in the Boat
Make sure the Main Switch is turned OFF, open the Window Cover, and then remove it.
Put the two batteries to each Battery Holder which installed in the boat in advance, then connect each of them
with the corresponding electronic connector which on the electronic board. (See Pic.).
Attention:
a. When connecting the battery, make sure the wires are in corresponding colour that red is to red, blue is to blue.
b. Please pay attention the shorter line which on one of battery is only for charging. This time, you need not
connect.
c. Make sure the plugs are connected firmly so as to avoid any poor connection.
（
（
（
（
2
）
）
）
）
Set up Batteries in Transmitter
Put 8pcs of “AA” alkaline batteries correctly in the transmitter and check the power. (You also could choose lithium
battery as option.) For AD-1202 Remote Control, the transmitter alarms 1 time/second when the power voltage is
8.3-8.8V, which indicates the power is low and batteries can be used not for long, the transmitter alarms 2
times/second when the power is 8.3V below, it indicates the power is inadequate and new batteries are needed.
Attention:
a. Please pay special attention to the positive and negative poles when setting up
batteries.
b. New batteries are needed when the power is too low or inadequate.
Please note not new or insufficient batteries will serious influence the signal
strength!
STEP 2.
Power on & Check
Turn on the R.C. Transmitter, Main Switch [1] and Light Switch [3] in order, and check the lights on the boat.
Control the Transmitter and check the Bait Hopper, Propeller, Rudder and battery level.
