R
(SHEET 2 OF 2)
IS1592B(04/17)
PLUMBERS INSTALLATION INSTRUCTIONS
WATER EFFICIENT TAPWARE
'G' SERIES PLUS- WALL SINK EXPOSED SET
Installing the outlet (Fig.5)
Determine if the outlet (19) is to be fixed or swivel.
1) For a fixed outlet select the retainer (18a) or if 100 restricted
swivel is required select the smaller retainer (18b). Fit the
retainer (18a or 18b) into the spigot groove, as shown.
Ensure suitable lubricant is applied to the retainer &
'O'rings, then carefully slide the outlet (19) onto the spigot
of breech (11). Rotate the outlet (19) to align the hole in the
outlet with the threaded hole in the retainer (18a or 18b) then
fit screw (17a or 17b) and tighten using the 2mm allen key (3).
Important: The correct retainer/screw combination must be
used (18a/17a) or (18b/17b), as shown.
2)
Changing the indicator (Fig.6)
Loosen screw (2) using a 2mm allen key (3) & remove
handle (1). Remove screw (23) & washer (24) using a
3mm allen key. Push out retainer (26) & indicator (25).
1)
2)Push in new indicator (25) followed by retainer (26). Assemble
screw (23) with washer (24) then screw into the retainer (26) &
tighten with the 3mm allen key. Align handle (1) as before then
engage with insert (6) & tighten screw (2) with 2mm allen key (3).
Cleaning the Aerator Insert (Fig.5)
1) Carefully remove housing (20) from outlet tube (19), taking care
not to damage the decorative finish.
2) Remove 'O'ring (22) & aerator insert (21) from housing (20).
Check that housing is clean. Deposits of lime can be removed
by washing in a vinegar solution.
3) Fit aerator insert (21) into housing (20) followed by 'O'ring (22)
then screw assembly onto outlet tube (19) & tighten securely
(to prevent removal by hand).
Fig. 6
23
24
25
26
1
2
3
Fig. 5
11
18a
18b
19
20
21
22
Swivel outlet
'O'Rings
Spigot
OR
Wall/tile face
3
Fixed Outlet
17a
17b
