Carmanah 502, Руководство пользователя

Страница: 9 / 16

Owner’s Manual | Model 502
9
© 2008 Carmanah Technologies Corporation
Revised: August 2008
3.5 Automatic Light Control
The Automatic Light Control (ALC) function of the Model 502 light monitors the battery voltage and
reduces the light’s intensity level if the light is not receiving sufficient solar charging to maintain the
battery voltage.
If a light is set at the correct intensity setting for the available solar illumination, ALC is not required
except in unusual circumstances of poor solar illumination.
If the light is manually set at a higher intensity it will operate at that higher intensity during the summer
months, but may turn itself down during the winter months in definable steps. If you do not want the
intensity level reduced automatically, you must turn ALC off; see section
3.5.1 Turning ALC off or on .
Disabling ALC while also increasing the light's intensity beyond a sustainable level will
cause the battery to over-discharge and the light will fail.
3.5.1 Turning ALC off or on
Turning ALC off prevents the light from automatically adjusting the intensity level of the programmed flash
pattern based on the available battery voltage. If ALC is turned off, you must set the required intensity
level for the light.
Turning ALC on allows the light to automatically adjust the intensity level of the programmed flash pattern
based on the available battery voltage.
Turning ALC Off:
1. Transition the light (if required).
2. Enter the security code (if required).
3. Enter the flash code (if required).
4. Enter code 8 0 0 to turn ALC off.
8 0 0
Turning ALC On:
1. Transition the light (if required).
2. Enter the security code (if required).
3. Enter the flash code (if required).
4. Enter code 8 0 1 to turn ALC on.
8 0 1