Carlson Wireless USA revision 1.05 Page 4
UNPACKING
The i-WLL-15 system will arrive in one box approximately 32 x 16x 9 inches
(80 x 40 x 23 cm). Small amounts of feed cable and power supplies may also
be included in this box if ordered.
Caution!
1. There are 2 large U-bolts holding the outer housing to the mounting plate of
each system. The fasteners on these are self locking nuts. DO NOT TURN
OR ROTATE THESE NUTS. They are set to a specific torque and if over-
torqued the housing will distort potentially damaging the electronic modules
inside.
2. DO NOT REMOVE THE FRONT END CAP. The seal is not lubricated for
removal and reinstallation. All of the electronics and antenna assembly are
serviced though the rear (mount-side) end cap.
SCOPE OF MANUAL
This manual is designed to support the installation, operation and mainte-
nance of the
i-WLL–15
All-Digital Remote Wireless Telephone Link. To avoid
harm to persons or damage to the product please ensure that you have read
through the unpacking and installation sections before proceeding.
PRODUCT OVERVIEW
The i-WLL All-Digital, Internet-Ready, Remote Phone Link is a dual line,
point-to-point, spread spectrum telephone system that delivers v.34 data
rates, providing email and the Internet to your remote PC - as well as high-
quality voice! And both lines are fully independent and will transmit either
voice or data.
Carlson Wireless USA revision 1.05 Page 17
Radio interference
Carlson Wireless USA Model: i-WLL-15
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) This device must accept any interference received, including
interference that may cause undesired operation. Changes of modification not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment
.
Notification to the telephone company cont’d
The REN is useful to determine the quantity of devices you may connect to
your telephone line and still have all of those devices ring when you telephone
number is called. In most, but not all, areas, the sum of the REN’s of all de-
vices connected to one line should not exceed five (5.0).
To be certain of the number of devices you may connect to your telephone
line , as determined by the REN, you should call your local telephone com-
pany to determine the maximum REN for your calling area.
Jack Types Needed
Connection to the telephone network should be made by using standard
modular telephone jack types (USOC) RJ11C or RJ11W.
Incidence of Harm
If your telephone equipment cause harm to the telephone network, the tele-
phone company may disconnect your service temporarily. If possible, they
will notify you in advance. But if advance notice is not practical, you will be
notified as soon as possible. You will be informed of your right to file a com-
pliant with the FCC.
Rights of the Telephone Company
Your telephone company may make change in it’s facilities, equipment, op-
erations or procedures that could affect the proper functioning of your equip-
ment. If they do, you will be notified in advance to give you an opportunity to
maintain uninterrupted telephone service.
Coin Service or Party Use Line
This equipment may not be used on the coin service provided by the tele-
phone company. Connection to party lines is subject to state tariffs.
