Carlos mendoza Showco Wash 575, Руководство пользователя

Страница: 5 / 21

5.Installion
To insert the lamp MSR 575/2 95V/575W GX-9,5 loosen the lamp cover at the rear of
head (see the drawings ) by remowing the 3 fastening screws which are marked "X,Y,Z" .
Carefully pull out the cover with the lamp socketassembly.If changing the lamp, remove
the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the
device is not de-signed for.Damages caused by non-observance are not subject to warranty.
Please follow the lamp manufacturer notes!Do not touch the glass-bulb with bare hands
during the installation! Make sure that thelamp is installed tightly into the lampholder
system.
Reclose the lamp cover and tighten the 3 screws.
.Lamp assembly:
5.1 Fitting the lamp
Lamp cover
Do not operate this fixture with opened housing-cover!
5.2 Lamp adjust
The WASH 575 lampholder is aligned at the
factory. Due to differences between lamps ,
f i n e a d j u s t m e n t m a y i m p r o v e l i g h t
performance.Strike the lamp,open the shutter
and the iris,set the dimmer intensity onto
100% and focus the light on a flatsurface
(wall).Center a hot-spot(the brightest part of
the image) by using the 3 adjustment screws
"A,B,C".Turn one screw after another a
quarter-turn clokwise(counter-clokwise. If
you cannot detect the hot-spot,adjust the lamp
until the light is evenly distributed.
3 phillips screws "X,Y,Z"
Remove the screws X,Y and Z for re-lamping
WARNING!
Disconnect the fixture from AC power before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min.Before opening the covers
and removing lamp from the fixture.
Maximum room temperature ta=40
Minimum distance from flammable material d=0.5m.
Exterior surface temperature T=80 .
Not for domestic use.
X X
Z Z
A A
B B
Adjust lamp position by turning screws A, B and C
3 adjustment screws "A,B,C"
Remove the screws X,Y and Z for re-lamping
WARNING!
Disconnect the fixture from AC power before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min.Before opening the covers
and removing lamp from the fixture.
Maximum room temperature ta=40
Minimum distance from flammable material d=0.5m.
Exterior surface temperature T=80 .
Not for domestic use.
X X
Z Z
A A
B B
Adjust lamp position by turning screws A, B and C
4
www.carlosmendoza.com.mx