INSTALLATION INSTRUCTIONS
This low voltage floor bracket assembly is
designed to be mounted on a joist or subfloor.
It can be installed on the top of the joist or
from the bottom if the thickness of the joist is
sufficient to allow installation of the bracket. If
the unit is to be installed from the bottom of
the joist, check prior to installation to ensure
there is sufficient adjustment remaining as this
type of installation is non-standard.
The unit can also be installed using the metal
old work (small) bracket that is included. This
metal bracket facilitates the installation of the
low voltage orange floor bracket in areas where
the larger new work metal bracket cannot be
used. The old work metal bracket edge is hidden
by the cover when installed. However, before
cutting into the wood floor or subfloor, ensure
that the mounting screws will properly support
the bracket installation, and make sure there
are no wiring, plumbing lines, heating and air-
conditioning ducts, or any other obstructions
that could be damaged.
For planning purposes ensure that the maxi-
mum installed height to the bottom of the cover
does not exceed 1-3/4" above the top of the
metal mounting bracket.
The kit is listed as a low voltage floor bracket
by Underwriters Laboratories. Only covers
manufactured for this box can be used with
this assembly.
Install clip over subfloor.
Screw in to adjust to height
of flooring or carpet.
Beautiful flush fit every time!
81UN
Floor Bracket
Assembled in USA
Gross Automation (877) 268-3700 · www.carlonsales.com · [email protected]
