14
Carlo Gavazzi Controls S.p.A.
SBPBASEA
SBPBASEA ENG
15/04/2019
SBPBASEA mounting
Place the sensor with the vertical mark at the tip of the triangle base.
Turn the sensor clockwise until the vertical mark is positioned at the rear end of the triangle. The sensor is now
attached to the base.
Release the sensor by turning it anti-clockwise.
D+
D-
POW
a
b
Fig. 5
Basepart: mounted on the
ceiling
Fig. 6
Mount / Unmount
When mounting the SBPSUSxxx sensor on the ceiling, the sensor must be installed at an angle of maximum
± 5 degrees deviation from the ceiling surface.
Mount the SBPBASEA and the sensor (SBPSUSL45 only) with a maximum horizontal deviation of ±2 degree
to have the best performance in terms of signal reliability.
See drawing below.
MAX ±5°
MAX ±2°
Fig. 7
Maximum ±5° vertical deviation
Fig. 8
Maximum ±2° horizontal
deviation. Bottom view
Make sure that there is some extra wire for the sensor so that maintenance of the sensor/base in the future is
enabled. Also place the wire correctly to avoid damage to the cable isolation.
