Car Park 3 – General installation
17
3.6 Cabinet modules installation
The cabinets for all the DIN rail-mounted
Parking Guidance System
modules should be placed in
the middle of the system so to have a uniform load. This permits you to use only few cabinets and
to reduce the length of the cable to the sensors.
For further information, go to
How to calculate the cable length
If you reduce the length of the cable to the sensors, you can mount more sensors on the same
Dupline® bus.
Note: you can mount maximum 50 sensors in a line and connect maximum 90 sensors to a CMCG.
The cabinet(s) can be also installed away from the system or simply at the end of the system. If
you choose to ignore the rules mentioned in section
, we recommend to
calculate the load and voltage drop.
For further information, go to
How to calculate the cable length
