1d) After inserting both Panels, locate the two
large sockets on the front edge of the underside
of the Middle Panel
2d) Starting with the Right-Hand Door properly orient-
ed (right side as looking at the Cart), insert the large
peg on the top of the Door into the right socket under
the Middle Shelf.
3d) Applying firm
steady pressure, slide
the Door towards the
corner of the Cart until
the peg at the bottom
snaps into the right
socket located on the
top front edge of the
Bottom Shelf. You may
use the Rubber Mallet
to help slightly loosen the Middle Shelf on the edge immediately
above the Door if the fit is too tight. Remember to knock the shelf
back in place if you do this. When properly installed, the Door
should swing freely when opening or closing.
4d) Repeat steps #2 and #3
with the Left-Hand Door
2d
4d
Door Assembly:
Lock Assembly:
1d
3d
Lock
Door
Panel
Position Lock with notch side down
3/4” Nut
Clear Lock
Thread Protector
90° Stop
Washer
Offset
Toggle
Lock
Washer
Philip's
Head Screw
1
1) Insert the Lock through the opening in the door as shown with the notch on the bottom side, as indicated. Secure the
Lock with the 3/4” Nut , slide the Clear Lock Thread Protector over the threaded end of the Lock, making sure to push it on
completely so that it is flush with the 3/4” Nut as much as possible. Orient the 90°Stop Washer as shown and slide it on
the square portion at the end of the Lock. Orient the Offset Toggle, also as shown, and slide it over the square portion at the
end of the Lock. Secure these with the Lock Washer and Philip's Head Screw using a Philip's head screwdriver. . Using one
of the keys, the assembled lock should function as shown in the graphic below.
Door – Locked Position
Door – Unlocked Position
