Carlisle Binks 102-2400 FRP, Руководство по обслуживанию

Страница: 12 / 20

EN
77-2520-R15 (5/2019) 12 / 20 www.carlisleft.com
BINKS CENTURY GUN SUGGESTED SPARE PARTS
PART QTY.
DESCRIPTION
NO. PER PKG.
108-9XXYY 1 Tungsten Carbide Nozzle and 2 tip seals per nozzle.
(size determined by application)
XX = Orifice size in thousandths
YY = Spray width at 12"
106-1171 1 Repair Kit, Fluid Valves/Seats
106-1172 1 Repair Kit, Air Valve
106-1173 15 sets Kit, Nozzle O-Rings (20-4542, 20-6296)
106-1174 See Description Soft Seat Kit (10 Resin, 5 Catalyst)
106-1175 5 sets Catalyst Filter Repair Kit
106-1176 10 Tip Seal Kit (106-1176)
106-1177 10 Tip Seal Kit (102-2499)
102-25XX 1 Catalyst Injector
XX = orifice size in thousandths.
Actual size determined by application. (See injector chart)
102-2431 1 Air/Catalyst Cap
102-2494 1 Night Cap
Note: Most o-ring and seals are available in multi-packs. Consult your Binks distributor for availability.
However, it is very important that the atomizing air is turned
on first. Otherwise, initial catalyzation and spray pattern will
be poor upon triggering the gun. CHOPPER TRIGGER OPERATION
(102-2400 GUN ONLY)
The Century gun is equipped with a special chopper trigger (54).
This device allows simple on/off capabilities plus the ability to
run/load the chopper without triggering the gun at all. To set the
chopper trigger to its “on” position rotate the on/off selector (56)
as far clockwise as it will go. To set the chopper trigger to its
“off” position simply rotate the on/off selector as far counter-
clockwise as it will go. To run the chopper without triggering the
gun and, with the gun in your right hand, set the on/off selector
to “on”, place your right index finger on the trigger pad of the
chopper trigger sub-assembly (54) and pull back on the chopper
trigger until the chopper air valve (26) is engaged.
OPERATING INSTRUCTIONS (continued)
GENERAL MAINTENANCE
DAILY INSPECTION
1. Inspect the gun head o-rings (7 & 8) for cuts or tears and
replace if necessary.
2. Check the fluid needles (11 & 19) for signs of material
leakage. Tighten fluid packing nuts if leaks are present
until leakage stops. If leak does not stop replace the needle
packing or needle.
3. Inspect the tip seal (6) for wear or damage and replace
if necessary.
4. Inspect filters of system for build-up and clean if
necessary.
NOTE
With tip wear, resin flow will slowly increase.
NOTE
This can also be done by a left-handed operator, but it is
a little difficult to reach under the bridge of the handle to
actuate the chopper trigger.
NOTE
Do not soak o-rings in solvents (swelling will occur).