EN
77-3090-R2 (9/2019)
3 / 12
www.carlisleft.com
MOUNTING
Mount gun flush boxes to a sturdy metal stand,
wall, or support that is connected to an earth
ground. Conductive metal
flushing / solvent waste
container should be positioned directly below the
flush box.
Mount box with 4 ea. 1/4” or 6mm diameter screws
using dimensions shown at right. Remove the gun
saddle from the box to make mounting easier.
GUN FLUSH BOX KIT
Gun flush boxes are used to improve safety and minimize solvent usage and time when compared to manual
flushing of spray guns. Higher solvent and air pressures may be used, improving flushing efficiency.
Flush boxes may be installed on the GEMS system for one or two guns. In a two-gun installation the system
controller allows either gun 1 or both guns 1 and 2 to flush and load paint. The second gun may be disabled
by the administrator if necessary.
All pneumatic connections to the gun flush box are for 5/32” (4mm) OD tubing.
The gun flush box(es) must be enabled in the system software configuration, accessible only
by distributor. Contact distributor for installation and proper kit functionality.
!
CAUTION
Gun flush box(es) will generate vapors and
mists of paint and solvent and therefore
must be mounted in a spray booth or other
Class 1 Division 1 [Zone 1] Hazardous Area.
The gun flush box and conductive metal
waste container used for flushing must be
bonded to earth ground and continuity
checked with an ohmmeter .
Do NOT operate the gun flush box until
properly grounded.
!
WARNING
GUN BOX MOUNTING HOLE PATTERN