Strobe
– The Strobe button selects between ‘Sweep’ or ‘Strobe’ mode. The Tuner will remain in the Mode
chosen until the alternate has been selected.
On/Off Switch
- This switch determines whether the pedal is ‘active’ or ‘bypassed’ (on/off). This is a ‘True
Bypass’ switch.
Mute Switch
– This switch will mute the signal when engaged (on), for silent tuning.
INPUT
- Using a standard line cable with a 1/4” jack, connect your instrument to this jack.
DC 9V
- To use external power (not provided) use only a 9-Volt DC adapter. For details please refer to the
section POWER REQUIREMENTS.
OUTPUT
- Using a standard line cable with a 1/4” jack, connect this output to the input of your amplifier or
next accessory in the signal chain. This is a ‘True Bypass’ output. When the tuner is disengaged (off), your
signal will travel directly to your amp or effects chain without tonal sacrifice.
The Battery
is located inside the pedal. To install or replace the 9V battery, loosen the screws on the
bottom and remove the bottom plate. Be careful not to scratch the unit.
Always remember to unplug your cables from the pedal to conserve battery life. Some battery drain will take
place when the line cables are connected to the tuner, regardless if the tuner is engaged or not.
Power Requirements
Battery: Standard 9V Alkaline battery
Power consumption: max. 80 mA
Power supply:
* 9 V DC (regulated), 100 mA minimum
* 2.1 mm female plug, center negative (-)
ATTENTION: Please Use DC Power Supply Only!
Failure to do so may damage the unit and void the warranty.
Specifications
Precision…………………………±1 cent
Frequency range………………..A0(27.5 Hz)-C8(4186 Hz)
Residual Noise......................... -85 dB
Indicators....................................Calib, Note, Strobe
Connectors ............................... INPUT, OUTPUT,DC Adaptor jack
Power Supply ........................... DC 9V Adaptor (not included)
Current Draw ............................ max. 80 mA (DC 9 V)
Dimensions .............................. 120 (W) x 95 (D) x 56 (H) mm
4.72” (W) x 3.74” (D) x 2.2” (H)
Weight....................................... 420g/ 0.94lbs
Warranty:
Carl Martin Research warrants the manufacturing, material and proper operation for a period of
one year from date of purchase. Carl Martin will replace defective parts, make necessary repairs or replace
the unit at the discression of our technicians. The warranty applies only to the original purchaser of this
product, and excludes any damage or faulty operation resulting from misuse, neglect or unauthorized
service.
Manufactured in China
East Sound Research Raadmandsvej 24 8500 Grenaa Denmark Phone: +4586325100
E-Mail: [email protected]
