4
Wing
Installing Ailerons
1.
!
Collect the following parts:
(1) Wing
(2) Ailerons ( Left & Right)
(6) Mini CA hinges
1.
!
Locate the pre-cut aileron hinge slots in both
sides of the wing. Using a hobby knife (#11
blade), slide the blade into each slot to make
sure it is cleanly cut.
!
Repeat this process with the ailerons, making
sure all hinge slots are clean.
2.
!
Find the control horn slot near one end of the
aileron.
!
Align the slot in the aileron with the servo hole
in the wing.
!
Insert the mini CA hinges half way into the
wing and the ailerons. (Use a pin inserted into
the middle of the hinge to help keep the hinge
in the middle.)
!
Make sure that the aileron is tight against the
wing and even with the wing tip.
!
Using thin CA glue, place one drop on all
hinges top and bottom.
3.
!
Mount the aileron servo using the hardware
provided by the radio manufacture.
!
Remove the covering on the aileron where the
control horn sits.
!
Using glue, attach the control horn to the
aileron.
4.
!
Find the small aileron pushrod wire, and place
a “z” in one end.
!
Connect the pushrod wire to the servo arm
using optional mini-pushrod connector,
OR
by
using a felt marker, mark were the wire cross-
es the servo arm hole.
!
Bend the pushrod wire 90 degrees at the mark,
and slide the pushrod wire through the servo
arm hole from the bottom.
!
Hold the pushrod wire on to the servo arm by
using a single keeper.
Single Keeper
Servo Arm
Aileron Servos
1.
!
Collect the following parts:
(1) Wing
(2) Servo with hardware
(2) Aileron pushrod
(2) Mini pushrod connectors (Not Included)
(2) Single Keepers
(2) Adjustable Horn Brackets
!
Repeat for the other aileron.
