Carico ULTRA TECH CLEAN MACHINE, Руководство пользователя

Страница: 15 / 26

EN 15
2.2
ATTENTION
Parquet and other delicate floor surfaces
When steam cleaning parquet or other delicate floor surfaces, check with the
manufacturer if it is suitable for steam cleaning. Use only a small amount of
steam to avoid causing damage. Always test in a discreet, small area before
doing the entire surface. Work on a small area out of the way in order to see
how the parquet reacts to steam cleaning. Do not place the brush directly
on the wooden surface but kept at a distance. See how the wood reacts.
There are many different types of parquet and each may react differently. If
the surface has no negative reaction from the steam, then you may slowly
start working with the brush on the floor and slowly add more steam, always
keeping in mind that the parquet may not show negative sign of reaction to
the steam right away.
If you find resistant dirt, work the localized area with steam in order to soften
the dirt until it can simply be removed.
Give the dirt time to soften or liquefy prior to removal. After following
these steps you can now easily vacuum up the dirt by tilting the brush
back to the parallel position.
How to use the floor accessory with bristles
Use for vacuuming all delicate surfaces such as parquet where you wish to
avoid scratches from the rougher profile of the Carpet Accessory 7.2.1.
Use brushes to loosen dust and dirt before vacuuming. Use it on tiles to
remove dust and light dirt. Always use delicately and without any liquid on
the floor so that the bristles stay clean and do not wear down quickly. Do
not use to scrub.
ATTENTION! Never attempt to use this accessory with steam!
GENERAL USE
Very dirty surfaces
First use an attachment with the bristles without steam to remove most of
the dirt, then use the steam, allow the steam time to dissolve the dirt. Lastly,
turn on the vacuum and go over the surface by tilting the brush forward,
drying and vacuuming the dirt.
Medium dirty surfaces
Operate with both steam and vacuum (depending on the accessory used;
remember to heat up the unit first to deliver perfect steam), then turn off the
steam. The brush must always be tilted forward (to facilitate vacuuming). After
finishing work, do not stop the vacuum immediately, to allow the dirty water
still inside the tube and hose to reach the recovery tank. Tilt the brush face up to
avoid any dripping.
Carpets and rugs
Attention – always thoroughly vacuum your carpet or rug before using
steam to avoid any dirt getting moist and sinking deeper into the carpet. The
appliance can clean and disinfect any kind of carpet or rug with the exception
of long-haired rugs, these will tend to close the water jets and lead to bad
filtration. With rugs made of sheep's wool please test on a small section
before steam cleaning the whole rug, the heat may cause a change of color
in the wool or lead to shrinking. Steam cleaning will revive color, restore the
original thickness and eliminate impurities from the carpet bottom layer. If
your carpets and rugs are dusty on top, start by using the big brush with
vacuum only. After vacuuming, use the appliance with simultaneous action
(steam+vacuum), according to the same procedure recommended for
medium dirty surfaces. With particularly stubborn and crusty stains, we
recommend the use of 1 Hole Dress-Fit (8.3) + Brush (7.3.2).
If you want to pre-treat a spot, use only natural, safe products. CAUTION!
!