7
The steering wheel is powered with 2 type ‘AA’ 1,5 V batteries (not included).
WARNING: The batteries must always be replaced by and adult person.
WARNING: Never leave batteries or tools within the baby’s reach.
WARNING: Never leave this product exposed to rain - water and humidity may damage the electrical
circuits.
WARNING: Always remove worn out batteries from this product, to eliminate possible leaks that may
damage the product.
WARNING: Remove the batteries if this product is not used for a longer period of time.
WARNING: Alkaline batteries are recommended for use with this product.
WARNING: Never use different battery types at the same time, nor use old and new batteries at the same
time.
6
ASSEMBLY INSTRUCTION
Moving on a ride-on is done by pushing off the ground with your feet. Moving the steering wheel to the
left / right allows you to change the direction of travel.
To assemble the ride-on wheel, turn it upside down with the chassis. Attach the J-shaped steering rod as
shown in the picture (1). Attach the handlebar and the fixed part of the safety bar to the handlebar hole.
Tighten the steering wheel with the bolt and nut, making sure that the steering rod is mounted on the
front axle (2). Install the backrest (3). Remove the cotter pin from the tube (4), fasten the tube to the rod
with 2 bolts and nuts and then fix the whole thing in the hole on the back of the car body (5) and secure
it with the cotter pin. Remember that the split pin should be hooked as shown in the picture. Then attach
the armrests in the appropriate places using the clips (6). Attach the cup holder with the screw (7) and
insert the batteries into the handlebar (8).
7
BATTERY USE INSTRUCTIONS
The ride-on car is equipped with the function of making sounds. To use this feature,
open the battery compartment cover at the bottom of the ride-on, insert 2 1.5V AA batteries according to
the polarity markings inside the compartment and close the cover (9).