P
IONEER
L
ITE
P
ATIO
A
WNING
4
I
NSTALLING THE
A
WNING
Awning Width
Fabric Width
5.5”
5”
5”
Awning
Rail
Floor Line
90
o
typ
Arm Latch Lever
Manual Crank
2.25”
6” minimum
(Door to Awning
Rail Clearance)
PL001
68”-81”
Figure 1. General Layout
A
SSEMBLING THE
A
WNING
#10 x 5/8 Square Drive Screw
(3 per end cap)
Align the Cap Access Slot
and the Roller Slot w/ the Polyrod
Orient Roller Tube with Fabric
Winding Over the Top
PL003
Figure 2. Assembling the Awning.
1.
On a flat surface, layout the arms and roller tube assembly. Note: Position
the roller tube with the fabric oriented as shown, over the top the the edge
toward the vehicle.
2.
Slide the idler end plug (LH arm) onto the roller tube. Align the fabric access
slot in the cap with the roller tube slot w/ the polyrod. Attach the cap to the
roller tube using three (3) #10 x 5/8 square drive truss head screws.
3.
Repeat for the RH arm.
