Carefree PARAMOUNT, Руководство пользователя

Страница: 8 / 16

Carefree of Colorado
8
The remote has a maximum operating range of 50 feet. Actual distance may vary
depending on the specific installation and location of the receiver in the vehicle.
R
EMOTE
T
RANSMITTER
B
ATTERY
The remote uses two standard AAA Batteries that should provide a long period of
service. To access: open the access cover on the back of the case. Batteries
are available through your local battery outlets.
P
ROGRAMMING THE
RF R
ECEIVER FOR A
R
EMOTE
When adding or replacing a remote control, it
is necessary to program the transmitter and
receiver.
1. Power to the control box must be on.
2. Locate the receiver box.
3. Press and release the “Press to Learn
Transmitter” button on the bottom of the
receiver box. The receiver is in program
mode when the red light comes on.
4. Press and release any button on the remote,
it is recommended to use the stop button.
The red light will go out after the receiver
learns the remote signal.
CAUTION
Any button on the remote may be pressed. When the
receiver learns the transmitter signal the system will perform the operation
of the button pressed. Example: Pressing an "Extend" button during the
learning phase will cause the awning to extend when the receiver learns the
signal. Use caution to avoid unexpected movement by the awning.
5. Repeat steps 2 and 3 for each additional remote.
OPERATIONAL NOTES:

Transmitter and receiver operate on a frequency of 433MHz.

The receiver exits the program mode after ten seconds.

If the light does not come on in step 2, check the continuity of the cord
between the boxes and repair or replace as required. Pin 1 of the 1
st
connector goes to pin 1 of the 2
nd
connector etc. If the light still does not
come on, the memory is full and must be cleared.

If the light does not go out in step 3, the receiver already knows the
transmitter's signal or the battery in the remote needs to be replaced.

To clear the memory:
PRESS AND HOLD
the transmitter learn button.
While holding the button, the indicator light should be OFF for the full 5
seconds then come on.

The system may be programmed for up to 5 remotes. Additional
remotes may be ordered separately.
DR020
TO EYE POR
T
on RP24 Program Mode Press to Learn T
ransmitter
UP
Program
Button Indicator
Light
RR