F
REESTYLE
E
VOLUTION
Service
Manual Carefree of Colorado
10
070036-301Prelim
M
OTOR
R
EPLACEMENT
P
RELIMINARY
S
TEPS
(A
LL
C
ONFIGURATIONS
)
1. Disconnect power to the awning.
2. If the awning is extended: Carefully push the lead rail toward the case so
that the arms collapse. While holding the lead rail in this position, firmly tie
the elbows of the spring arms together. Use a minimum 1/2" rope - do not
use bungee cords. When tying the rope, use a non-slip knot such as a
square knot or equivalent.
3. If the awning is closed: Firmly brace the lead rail in the closed position. A
second person can hold the lead rail steady during the disassembly
process.
CAUTION
If the awning is closed when the motor and end cap screws are removed, the
spring arms will try to extend out possibly causing personal injury and damage to the awning.
Support the roller tube and allow the awning to open slowly then secure the arms by tying the elbows
together as described above.
CAUTION
Failure to secure the lead rail as described will allow the spring arms to unexpectedly
extend out possibly causing personal injury and damage to the awning.
R
EPLACING THE
M
OTOR
(R
IGHT
A
NGLE
G
EAR
)
1. Remove the motor end cap and set aside.
2. Disconnect the motor wires from the harness.
3. Remove the motor screws (x2) and the endplate
screws (x5) and set aside.
4. Pull the endplate away from the case.
5. Pull the old motor out of the roller tube and set aside.
6. Place the one-way drive onto the new motor.
6.1. For RH motors the "B" points toward the motor.
6.2. For LH motors the "A" points toward the motor.
6.3. Secure with the new clip.
NOTICE
If the drive is not oriented correctly,
the awning will not operate and the arms will
spring out when released.
7. Align the one-way drive with the roller tube and start
sliding the new motor into the roller tube.
8. Align the bearing on the motor and slide into the
roller tube.
9. Attach the end plate to the motor with the motor
screws removed previously.
10. Align the screw holes in the end plate and attach
to the awning case.
11. Attach the motor wires. Fold and tuck the wires and connectors to fit inside the end cap.
NOTICE
Wire colors do not match between motor, limit switch and harness. Use the wiring
diagram on page 12 to ensure correct connections for the motor configuration.
12. While holding the lead rail, carefully remove any roller tube supports and arm ties. Allow the lead rail to extend
until the fabric is taut. If the lead rail continues to extend after the fabric is taut, the one way drive was installed
backwards. Tie the arms, remove the motor and orient the one way drive as shown.
13. Attach the end cap.
FRM007
Spring Arms
Firmly Tie Elbows Together
Endcap
Motor Screws (x2)
ragm015
One-Way Drive
RH Motor
LH Motor
Clip
Endplate Screws (x5)
“A”
“B”
Motor Spacer
Endplate Spacer
Endplate
Clip
Disconnect Motor Wires