Carefree Freedom WM, Руководство по обслуживанию

Страница: 15 / 29

Carefree of Colorado
Service Manual F
REEDOM
WM
052563-301r5 11
A
DJUSTING THE
M
OTOR
L
IMITS
Endcap Plug
WM011a
“OUT”
“IN”
4mm Hex
4mm Hex
Increase Run Time
Decrease Run Time
Increase Run Time
Decrease Run Time
Out Limit Switch
The “OUT” limit switch stops the motor when the awning is fully extended
1. Extend the awning out completely.
2. Confirm that the arms are fully extended. The motor should stop and the fabric should be tight. If the
motor continues to run, the fabric will sag; or, if the motor quits before the arms are fully extended, it
will be necessary to adjust the “
OUT
” limit switch.
3. Using a 4mm Allen wrench turn the “
OUT
” limit switch. C
LOCKWISE
increases time the motor runs
during extension,
COUNTERCLOCKWISE
reduces the time the motor runs.
NOTE: It is best to make the adjustments in increments of a single turn. 3 full turns of the screw
equals approximately 2” of fabric extension.
4. Extend and retract the awning several times to confirm that the adjustment is correct.
5. Repeat steps 3 and 4 as required until the awning extends correctly.
IN Limit Switch
The “IN” limit switch stops the motor when the awning is fully retracted.
NOTICE
The in-limit switch must be set to shut off the motor when the awning is closed. The
motor must not continue to run after the awning is closed otherwise damage to the motor will occur
if the motor continues to run after the awning is closed.
1. Retract the awning in completely.
2. Confirm that the arms are fully retracted. The motor must stop when the awning is fully retracted. If the motor
continues to run; or, if the motor quits before the arms are fully retracted, it will be necessary to adjust the “
IN
”
limit switch.
3. Using a 4mm Allen wrench turn the “
IN
” limit switch. Clockwise increase time the motor runs during
retraction, counter clockwise reduces the time the motor runs.
NOTE: It is best to make the adjustments in increments of a single turn. 3 full turns of the screw
equals approximately 2” of fabric extension.
4. Extend and retract the awning several times to confirm that the adjustment is correct.
5. Repeat steps 3 and 4 as required until the awning retracts correctly.