Carefree ECLIPSE 2015, Руководство по обслуживанию

Страница: 18 / 45

E
CLIPSE
Service Manual Carefree of Colorado
14 052547-301r10
D02 (
CONT
)
E Test Switch Function – Single Switch Installation (this test requires a continuity tester)
The Patio Switch used in the Single Switch Installation is a center on that is internally cross-wired to short in the
center position to provide dynamic braking for the motor to prevent "drift" when the awning is stopped.
Test 1 is for Series I & II switches. Use Test 2 for Series III switches.
Observe continuity for switch in center position, extend position and retract position.
1a Place one lead of tester
on pin 2B. Touch 2nd
lead to the other pins
one at a time.
Pin: Center Extend Retract YES Test OK, all checks pass – go to step
1b
3 N Y N
6 Y N Y
5B Y N N NO Test failed; switch defective - replace
N = no continuity, Y = continuity
1b Place one lead of tester
on pin 5B. Touch 2nd
lead to the other pins
one at a time.
Pin: Center Extend Retract YES Test OK, all checks pass – Revaluate
problem, cause is not electrical
3 N N Y
6 Y Y N
NO Test failed; switch defective - replace
N = no continuity, Y = continuity
Test 2 is for Series III switches. Use Test 1 for Series I & II switches.
Observe continuity for switch in center position, extend position and retract position.
2a Place one lead of tester
on 12V pin (3). Touch
2nd lead to the other
pins one at a time.
Pin: Center Extend Retract YES Test OK, all checks pass – go to step 2b
2 N N Y
4 N Y N
N = no continuity, Y = continuity NO Test failed; switch defective - replace
All other pins should be NO in all
switch positions
2b Place one lead of tester
on Ground
1
pin (1).
Touch 2nd lead to the
other pins one at a time.
Pin: Center Extend Retract YES Test OK, all checks pass – go to step 2c
2 Y Y N
N = no continuity, Y = continuity NO Test failed; switch defective - replace
All other pins should be NO in all
switch positions
2c Place one lead of tester
on Ground
2
pin (5).
Touch 2nd lead to the
other pins one at a time.
Pin: Center Extend Retract YES Test OK, all checks pass – Revaluate
problem, cause is not electrical
4 Y N Y
N = no continuity, Y = continuity NO Test failed; switch defective - replace
All other pins should be NO in all
switch positions
Travelr019
Note:
The Series II switch terminals are not labeled.
The illustrations are labeled for identification purposes
in the procedures above.
Series I Switch
(Retract)
(Extend)
(Center)
6
5B
4
3
2B
1
Series II Switch
(Retract)
(Extend)
(Center)
(6)
(5B)
(3)
(2B)
Travelr019a
Note:
The Series III switch terminals are not labeled.
The illustration is labeled for identification purposes
in the procedures above.
(Retract)
(Extend)
(Center)
Ground
1
(1)
12V (3)
Retract (2)
(5) Ground
2
(4) Extend
Series III Switch