C
AREFREE OF
C
OLORADO
A
WNING
S
TABILZER
P
OLE
K
IT
2
B
OX
A
WNINGS
Always observe the notices on the 1
st
page.
1. Press the lead rail grip over the pin on the pole.
No tools required. It is not necessary to remove the grip for storage
2. Open the awning and set the desired pitch according to the product documentation.
3. Loosen the lead rail grip knob.
4. Squeeze the finger tabs to open the
grip jaws.
5. Place jaws over back edge of lead rail
and release the tabs.
6. Rotate the pole until it is vertical to
the ground and tighten the knob.
7. Loosen the locking knob on the
vertical support. Adjust the height of
the support then tighten the knob.
NOTICE
Do not use the
supports to adjust the awning’s
pitch. Use the awning’s pitch
adjustments prior to installing the
supports.
The poles may be adjusted from 56" to
108".
9. Place a stake through the D-ring of
the tension strap. Then drive the
stake into the ground approximately
5'-6' in front of the awning.
8. Place the D-ring on the other end of
the strap in the hook of the grip.
9. Tighten the strap by pulling the open
end of the strap through the tension
adjustment rings.
NOTICE
Always remove the supports before retracting the awning. Retracting the awning with the
supports and tie-downs attached can damage the awning.
ast002
Tension Adjust
Rings
Stake through
D-ring
Tension Strap
(2 total)
Vertical Support
(2 total)
Loosen
5'-6'
Tighten
Stake through
Foot
Squeeze Finger Tabs
to Open Grip Jaws
Place Jaws Over
Edge of Lead Rail
Release the Tabs
Place D-Ring
in Hook of Grip
Locking Knob
Lead Rail
Grip
ast004
