3
FEATURES:
•
Easily Programmable Keypad
•
Up to 1000 Personal Code Numbers
•
2 to 6 digit entry code length
•
Microprocessor based memory
•
Lightning and Surge protection built in
•
4 LED status indicators
•
Audio tone buzzer is shipped as a standard feature but not required. Units can be ordered without this feature
•
Built in timer for remote exit door switch or fire access key switch
•
Latching Relay to hold gates or doors open
•
Rugged Heavy Duty Metal Housing
•
Powered from a 10 Volt to 30 Volt AC or DC source
•
Highly vandal resistant
•
Fully sealed metal push button keyboard
•
No code number loss with a power failure (EPROM MEMORY)
•
Night Light illuminates brighter when any key is pressed
•
Timed anti-pass back and keypad lockout
TECHNICAL NOTES:
•
The user of the keypad has up to 30 seconds to key in their entry code.
•
All digits of the personal code number must be entered followed by the # key. If the # key is not pressed, with
correct code entry, activation will be sent within ½ second after the last correct access code / digit is pressed.
•
To avoid ESD (electrostatic discharge) interfering with the operation of the keypad, ground the housing.
•
Lightning and Surge Protection is built into the keypad. However, if you install a keypad in an area where lightning
can damage the keypad, make sure to install a Model 306, Lightning & Surge Protector for extra protection. There
is no warranty if the keypad is damaged by lightning, static electricity or high voltage surges.
•
The keypad automatically senses voltage from 10 to 30 volts AC or DC. Current draw is 10 mA typical and 150 mA
max.
•
Output of Relay 1 is Form C, 5 Amps. Output of Relay 2 is Form C, 1 Amp.
•
The keypad has a built in timer for remote exit. A door exit switch can be wired from the keypad to a Normally
Open
push button exit switch or to a fire access key switch to provide “codeless”
free exit or entry to authorized
personnel.
•
When pressing any number on the keypad it will activate the Night Light to a brighter state for the duration of
entering your code numbers.
•
The latching relay code (TOGGLE Mode) will hold gates or doors open.
Too many incorrect code number entries will cause a lockout condition and the Yellow LED will blink six (6) times
or more.
•
This keypad has 10-30 volt, AC or DC, automatic detection. Typical access control voltages are 12 to 24 volts.
Connecting directly to 110-120 volts single phase will damage the keypad and void the warranty. Make sure a
step-down transformer is used with a secondary voltage of 10-30 volts.
•
When supplying DC power
–
Polarity Must Be Observed
.
