25
7.8 ASSEMBLING THE SCOOTER
Suggestions
The assembly process is essentially the disassembly process in reverse. First study the text and
photographs in the disassembly procedure before re-assembling the scooter.
1. Position the front and rear sections of the scooter
2. Align the lower curved locking brackets of the front section with
the corresponding pegs on the front of the rear section.
3. Holding the seat post, slowly pivot the rear section forward until
the curved locking brackets are fully connected onto the top rear
pegs.
4. Secure the lock pin into the pin hole.
5. Loose tiller adjustment knob, raise the tiller, then retighten the tiller
adjustment knob.
6. Reinstall the batteries and secure them with the hook and loop strap.
7. Connect the front-to-rear harness and battery cables
8. Reinstall the rear shroud.
9. Replace the seat and rotate it until it locks into its correct position.
Warning
After assembling the scooter, make absolutely certain the tiller adjustment knob is fully
tightened. .
