23
6 . INS PECT ION A ND MA I N T ENA NCE
Attention
：
When tyre tread depth is below 0.5mm the power chair may not grip well making
braking distances longer. Therefore replace the tyres as soon as they are found to have
insufficient tread depth.
Attention
：
Before carrying out any maintenance, turn the power switch to OFF and remove the
charger cords.
Suggestions
：
1 .Do not splash water onto the power chair as this could cause the electronic system to
malfunction.
2. Do not use caustic materials, solvents or aerosols as these may damage the shrouds.
3. Do not use wax.
STORAGE
Make sure the Easi Go chair is stored:-
-
With the charger unplugged
-
With the power switched OFF
Suggestion
：
Always store the Easi Go power chair out of direct sunlight, rain or damp conditions. If
storing for an extended period, charge the battery to full power and then disconnect the
battery terminal. For details contact CareCo Customer Services on 0845 611 8022.
DISASSEMBLING THE POWER CHAIR
The Easi Go can be disassembled into four pieces, the seat (weight 8.2 kg), the front section
(weight 12 kg), the rear section (16.1 kg) and battery pack (weight 9.6kg), without any tools.
Please follow these steps:-
1.
Switch off power to the power chair.
2.
Disconnect the electrical connector from the rear shroud.
3.
Push the Seat Rotate Lever whilst pulling up on the seat to remove it.
4.
Remove the battery pack.
5.
Lift the power chair using the seat post, whilst pulling the red handle behind the seat post.
6.
Lift the front section up until the lower pegs are not in contact with the curved locking
brackets on the rear section.
