Your Abilize scooter is equipped with two sealed, maintenance free 12V. 22Ah.
Rechargeable batteries and one 24V/3A charger. Batteries must be charged before using
scooter for first time and should be recharged after each day’s use. Be sure power switch
is in OFF position and free-wheeling lever is not in freewheel mode.
For safety reasons, only sealed non-spillable batteries that meet DOT CFR 173.159(d), IATA
Packing Instructions, and IATA Provision A67 shall be installed in the scooters. If you need
new batteries, contact your dealer. Only 12V. 22Ah Valve-regulated Lead Acid batteries
should be used.
• Insert battery charger cord into Charging Socket (P) on battery pack.
• Plug other end of Power Cable (Q) into a standard electrical wall outlet.
• LED Indication
LED (Power) - RED Light on : Power on LED (Charge) - ORANGE Light on : Charging
GREEN Light on : Fully charged
• Allow batteries to charge until charging indicator turns green. For optimum performance a first
initial charge of 24 hours is recommended and 12 hour charge after every use.
• After indicator turns green, unplug battery charger from scooter and wall outlet.
• Do not charging simultaneously with battery box socket and optional charging socket, this will
cause serious risk.
• If at any time battery charger light flashes green over 40 minutes, this indicates abnormal
charging occurred. You should check the following:
1. Charger plug is correctly positioned.
2. Scooter is turned off.
3. If none of these are the problems, contact your local authorized dealer.
CAUTION: The time needed to recharge will vary depending on the depletion of the
batteries. Charging for longer than necessary will not harm the batteries. They can not be
overcharged.
Instruction Booklet: Charging the Batteries
08
P
Optional Charging
Socket (P1)
Содержание abilize strider sport MS01066
Страница 1: ...Code MS01066 Instruction Booklet ...