User Manual: um_xr600_cardiolinespa_09_eng1
11/36
Cardioline S.p.A.
Via Linz,19-20-21
38121 Spini di Gardolo (TN) [email protected]
Sede commerciale: Via F.lli Bronzetti, 8
20129 Milano (MI) Italia
tel.+39 02 94750470 fax +39 02 94750471
xr
600
The machine cannot be used without safety parts and devices well mounted or not efficient because they
could create electric risks.
3.7 ELECTRIC REQUIREMENTS
Connect the machine to 220
240 volt electric circuit, frequency 50
60Hz, with plug to hearth of
minimum 12 Ampere for range XR600 treadmills.
Range XR600 treadmills at normal functioning absorbs 2000 VA about.
Every machine has its electric wire and plug. The plug must be connected to a socket correctly
installed on the basis of local laws.
3.8 WORKING PLACE
The working place of the machine must have:
Temperature: from + 5 °C to + 30 °C Moisture: from 20 % to 90 %.
If the treadmill is transported or stored with temperature below 0°C and then positioned into the working
place with above mentioned temperature, please wait about 1 hour before turning it on in order to avoid
the console thermic shock.
The machine cannot be used outdoor and in rooms with fire or explosion risk. The user must be in front of machine
console. The ambient conditions cannot create uneasy situations (noise, high beam lights, etc…)or physical and psychical
stress to the user. Before installing the machine please calculate the minimum spaces around it necessary for turning
around, cleaning, service and out of hot sources.
3.9 HOW TO STABILIZE THE TREADMILL
Check the treadmill be on stable surface and, if necessary, adjust the rear feet after that block the two M20 bolts until
stability is achieved.
3.10 HOW TO CENTRE THE RUNNING BELT
The treadmill has a belt self-centring system. If the belt goes to right or left side, please control that the treadmill is
well steady on the floor (see 3.9 how to stabilize the treadmill). To centre the belt, use the left rear screw with moving
of half a turn each time. Turning the screw rightwards, the belt will move rightwards while turning the screw leftwards
the belt will move leftwards.
3.11 BEST RUNNING BELT TENSION
To obtain the best belt tension, put the treadmill at 5 km/h speed, hold the side handles and press the belt with feet
stopping it with difficulty and feeling the front roller slipping. If the belt is easily stopped, it means that the belt is too
loose and it must be tight; on the contrary if the belt cannot be stopped, it means that the belt is too tight and must be
released. For belt tightening or releasing, turn the right and left rear screw with moving of half a turn each time. Keep
the belt tight but not in tension.
TOO MUCH TENSION CAN MAKE THE BELT IRREPARABLE !
Содержание XR600
Страница 1: ...User Manual xr600 ...
