Fitting on a power supply cable
Opening the terminal board:
•
Using a screwdriver, prise on the side tabs of the terminal board cover
•
Pull open the cover of the terminal board
To install the cable, proceed as follows:
•
Remove the wire clamp screw and the three contact screws L-N
•
Fasten the wires beneath the screw-heads using the following color scheme;
Blue (N) Brown (L), Yellow - Green
•
Fasten the supply cable in place with the clamp and close the cover of the
terminal board.
Connecting the supply cable to the mains
When connecting the cable directly to the mains
,
install an omnipolar circuit-breaker with a
min
i
mum contact opening of 3 mm between the appliance and the mains. The omnipolar
circuit breaker should be sized accordmg to the load and should comply with current
regulations. (the earth wire should not
be interrupted by circuit breaker)
The supply cable should be positioned so that it does not reach a temperature of more than
50°C with respect to the room temperature, anywhere along its length.
Before making the connection, check that:
•
The electrical safety of this appliance can only be guaranteed if the oven is correctly
and efficiently earthed. Always ensure that the earthing is efficient. If vou have any
doubts, call a qualified technician to check the system. The manufacturer declines all
responsibility for damage resulting from a system which has not been earthed.
•
Before connecting the appliance to the mains, check that the specifications indicated
on the data plate (on the appliance and/or packaging) correspond to those of the
electrical mains system of your home.
•
Check that the electrical capacity of the system and wiring will support the maximum
power of the appliance, as indicated on the data plate. If you have any doubts, call a
qualified technician.
The disconnection can be achieved by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
1
9