Cardinal C15, Руководство по эксплуатации

Страница: 10 / 24

8526-M260-O1

C Series Operation
4
KEY FUNCTIONS, CONT.
PGM
The PGM key is used to add or edit product look up (PLU) numbers. Up to 99
PLU numbers can be programmed. Note that the first 9 PLU’s are assigned to
the P1-9 keys and that all PLU’s can be selected using the numeric keys.
P#
Pressing the P# key will cause the scale to recall the average piece weight
along with the saved tare weight (if a tare weight was programmed) associated
with the product look up (PLU) number.
P1
to
P9
Pressing these keys will cause the scale to recall the average piece weight
along with the saved tare weight (if a tare weight was programmed) associated
with the product look up (PLU) number assigned to the key.
C /
The C / key is used to perform different functions depending on the current
mode of operation:

Data Entry: The C / key is used to clear an incorrect entry from the
display without processing the data. If an incorrect entry is made, press
the C / key and re-enter the correct data.

Pressing and holding the C / key for 3 seconds will toggle the display
backlight on and off.
>0<
ZERO
The ZERO key is used to perform a variety of functions depending on the
current mode of operation:
Weight Display Mode (lb or kg annunciator on): Pressing the ZERO key will set
the weight display to zero and turn on the ZERO annunciator if the displayed
weight is within ± 4% of scale capacity.
>T<
TARE
The TARE key is used to display the current tare weight (or zero if no tare has
been entered) and/or using the numeric keypad, to enter a new tare weight. It is
also used when entering a tare under a Preset number.
UNITS Pressing this key will toggle the weighing units between pounds (lb) and
kilograms (kg). The currently selected weighing unit is indicated by illuminating
either the lb or kg annunciator.
0 ~ 9
These keys are used to enter numeric data during normal operations as well as
during calibration and operational setup.

This is the decimal point key. It is used to enter a decimal point where required
when entering numeric data.
Enter

The Enter/

key is used to signal completion of the entry of data and causes the
scale to process the data entered.