Cardinal Health Alaris 8300 Series, Техническое и сервисное руководство

Страница: 16 / 68

3. Enter a numeric value for the selected
alarm limit. Use the numeric keypad or
the up or down arrow keys to enter the
value. If a valid value appears in the
field for three seconds, the display
shows the prompt
> Press CONFIRM to
Apply Changes .
4. Press ENTER on the Point-of-Care Unit
to confirm the value. Once you press
ENTER , the next limit is highlighted and
the display prompts for an entry.
5. To change another alarm limit, press the
soft key for that parameter and enter a
new value.
6. Once all changes are complete, press
the CONFIRM soft key.
2.4.2 Limit Mode
NOTES:
• The following examples show adult alarm
limits for illustration. Follow the same
steps for neonatal alarm limits.
• If a profile is in use for programming, you
cannot change the Limit Mode.
1. To change the Limit Mode, toggle its
value from the System Config - EtCO
2
display, or use the Limits mode soft
key.
2. To toggle the value : From the System
Config - EtCO
2
display, press the soft
key for the Limit Mode selection. Every
key press toggles the value between
Adult and Neonatal.
3. To use the soft key : From the System
Config - EtCO
2
display, press the
Limits Mode soft key.
CHECKOUT AND CONFIGURATION
2-4
Alaris ® EtCO
2
Module (8300 Series)
Technical Service Manual
2.4 CONFIGURATION SETUP (Continued)
2.4.1 Alarm Limits (Continued)
Press the Limits
Mode soft key to
toggle between the
two acceptable
values