Carbolite Gero GPCMA 174, Инструкция по установке и эксплуатации

Страница: 28 / 50

7.4 Water-Cooled Door Seal Connections
The furnace has a silicone rubber door seal protected by a water-cooling system that
runs around the back of the furnace door. Water inlet and outlet pipes are situated at
the top of the door and connect to inlets and outlets on the top of the furnace.
l
The main water supply inlet
and outlets are situated at
the rear of the furnace beside
the gas supply inlet. Each
inlet / outlet is labelled.
l
The cooling water supply
pipes enter through the back
of the furnace case and exit
through two holes in the roof
panel.
l
The appropriate sized bulk-
head connectors are supplied
pre-fitted.
l
Cooling water inlet and outlet
pipes are fitted at the top of
the retort.
l
Water connection pipes are
supplied pre-bent to fit either
the inlet or outlet connection.
l
All furnace water connections
are supplied with 10mm com-
pression fittings.
l
Connect and secure the
water pipes in place by tight-
ening the nuts at the ends of
the pipes by 0.25 turns.
28