4. HOW TO USE THE MULTIFUNCTION DISPLAY
The multifunction display is designed to help the user know the capacity of the battery inside
power station and easily estimate the amount of usable charge left in the battery, and know the AC
output voltage & AC output power.
1. Please turn on the
Battery Main Switch
, to power the multifunction display.
2. Please press
“ON/OFF”
button to turn on the inverter and display, to check the Battery
Capacity and Voltage, AC Voltage and AC Power.
• When the voltage of battery is 13.2 volt or above,
Battery-Display (CHARGE LEVEL)
is full,
which doesn’t mean the battery charged 100% fully.
• Please charge the battery immediately, when
Battery-Display (CHARGE LEVEL)
goes down
to red sector, or the voltage is 11.0V or less.
• The value of AC-W(power) will be shown, when AC power is 30 watt or more.
• Mode 1 shows your selected informations from DC-V / AC-V and AC-W. Press the mode button
to switch through the display.
• Switch into Mode 2 by pressing mode button for 5 seconds and the Display shows automatic-
ally all informations in alternation (DC-V / AC-V and AC-W are shown every 3 seconds).
NOTE
: If using the multi-function Display while an externally connected device is still running, the
measured output voltage of the battery will be lower than if it is not connected to any device.
This is due to the electrical circuitry and is not a fault of the multifunction display. Please note the
multifunction display when the LithPowerUnit portable is completely disconnected from all external
devices.
16
CARBEST
LithPowerUnit 80 & 120
| 814136 / 814137
EN
