Carbatec SBW-6300, Руководство по эксплуатации

Страница: 14 / 32

p.14
Fixed machine:
To ensure sufficient upright stability of the machine and safety, you need to bolt the machine to floor on M16
screw. ( Fig. 1 )
Assemble the machine
(1) Attach the handle ( a, Fig. 2 ) to the hand wheel ( b, Fig. 2 ), Lock the screw then connect to the machine.
(2) To mount table, remove the table insert and table pin from the table, slide the table slot to the saw blade.
Slow moving to the center of table, make sure the table is located to the M10 holes ( Fig. 3 ) and attach the
spring washer then replace table insert and table pin.
(3) Adjust the table until the saw blade in the center of table insert, then locked with screw.
Adjusting 90 degree table stop
(1) Unplug power Cord.
(2) Loosen the quick table tighten handle (Fig. 5 )
(3) Adjust the table degree with patented table tilting mechanism until the table attach the 90 degree table
stopper.
(4) use a protractor placed on the table and against the blade to see if the table is 90 degree.
Assemble the machine
(1) Attach the handle ( a, Fig. 2 ) to the hand wheel ( b, Fig. 2 ), Lock the screw then connect to the machine.
(2) To mount table, remove the table insert and table pin from the table, slide the table slot to the saw blade.
Slow moving to the center of table, make sure the table is located to the M10 holes (Fig. 3) and attach the
spring washer then replace table insert and table pin.
(3) Adjust the table until the saw blade in the center of table insert, then locked with screw.
Adjusting 90 degree table stop
(1) Unplug power Cord.
(2) Loosen the quick table tighten handle (Fig. 5)
(3) Adjust the table degree with patented table tilting mechanism until the table attach the 90 degree table
stopper.
(4) use a protractor placed on the table and against the blade to see if the table is 90 degree.
Assemble rip fence
(1) Attach the ED rail to the table with screw M8.
(2) Setting the fence to the fence body, slide the fence on its guides until it is the required distance from the
blade.
(3) Check the scale, make sure the distance between the edge of the miter slot and both the front and rear of
the rip fence, adjust both distances are equal.
(4) Lock the fence by locking wheel.
Adjust the cutting height
(1) To adjust the cutting height by casting hand wheel (Fig.2), and check the mm/inch dual scale reading.(Fig. 9)
Adjust the tension
Blade tension is set by a spring located tension mechanism on the upper drive wheel, check the level of the
tension device before cutting. The tension for various blade widths are indicated on the window of machine.
(1) To adjust the tension hand wheel in front of table (Fig.10), and check the tension meter on the machine (Fig.11).
7. OPERATING INSTRUCTION