Carbatec RT-RPU2400, Руководство пользователя

Страница: 18 / 28

FOR TEC HNICAL SUPPOR T CALL 1800 658 111
RT-RPU2400
ASSEMBLY
INSTALLING THE BIT
Fig. 8-10
If the Router Power Unit is mounted in a
Router Lift, it is not necessary to remove
the motor from the lift to install a collet
assembly or a bit
Disconnect Power and raise the motor as high
as possible. Always wipe wood chips, dust,
or other foreign materials from the collet shaft
and collet assembly before assembling.
INSERT THE COLLET ASSEMBLY
INTO THE COLLET SHAFT.
Insert the bit shank into the collet
as follows:
1. Insert the bit shank into the collet as far
as it will go (Fig. 8).
2. Back the bit shank out slightly to avoid
bottoming out. Be sure there is a
minimum of 1.5mm between the bottom
of the collet assembly and the radius to
the cutting portion of the bit (Fig. 9)
3. To tighten the bit in the collet assembly
use two wrenches in the direction shown.
(Fig. 10).
Never tighten a collet assembly without
inserting a bit shank of the proper size.
This may damage the collet.
FIG. 8
FIG. 9
FIG. 10
1.5mm
TIGHTEN
18