Version 24.11.2017
RL-MZ72D
3.
Unplug the hazard light connector from behind
the AC vent.
4.
With the AC vent removed, unscrew the
10mm bolt holding the radio screen.
5.
Once the 10mm bolt is removed, the radio
screen assembly is secured with clips. Gently
pull the assembly until it pops out.
6.
Unplug the 28 pin connector from behind the
radio screen.
7.
Release the terminal lock by pulling it up with a
pry tool or any pointed tool. The terminal lock
does not fully remove!
8.
Connect the video ouput wires by inserting
the BLUE wire (Video ) into PIN 1 and
the GREEN wire (Video signal ground) into
PIN 15. Make sure that the pins are inserted
far enough into the connector to lock in
place. Press down the terminal lock to lock
pins in place.
