Version 01.09.2011
C2-MFD2
Pa
ge
11
4.3.
Switching between AV1 and AV2
After selecting the c.LOGiC as current AV source, push the right knob for 3 seconds to switch
between AV1 and AV2. Repeat to switch back.
Note:
If AV2 is deactivated (see chapter chapter Deactivating c.LOGiC AV2 input), it is not
possible to switch to the c.LOGiC’s AV2.
4.4.
Assigning device controls
After selecting the c.LOGiC as current AV source, longpress number “
1
” key.
The MFD will display “TV 1” and “RC01”. Turn right knob until the device-
related IR-code for AV1 as described in device control table (appendix A) is
reached. Press right knob to switch to “TV2” and repeat the procedure for
AV2. Push right knob to confirm the assignment.
If the vehicle has no MFD display in the instrument panel (for example in case
of retrofitted navigation systems), you must count the notches when turning
the knob (to the right +1, to the left -1). At the same time, remember that
the starting point is channel RC01 (the first notch to the right is then already
RC02).
Note:
The IR-control channel TV1 is preset to RC-Code 41 compatible DVB-T
tuners and TV2 is preset to RC-Code 09 for the usbLiNK.
If the AV2 is deactivated (see chapter chapter Deactivating c.LOGiC AV2
input), it is not necessary, nor possible to assign device controls.
4.5.
Button assignment table
The button assignment table shows which functions of the connected devices can be
executed by head-unit buttons. Once an AV-input is activated, the head-unit button in the
left column will execute the function described in the corresponding device column. The
function description equals the remote control buttons of the optional c.LOGiC remote
control or the additional device. On the additional device the writing may vary (e.g. AV
instead of Source).
