BEFORE USING A Ø 350 mm CUTTING TOOL
AGAIN, ALWAYS CHECK THE CORRECT
POSITION OF THE CUTTING HEAD LIMIT STOP
ADJUSTER.
The S-COUP 350 can be moved easily using the
carrying handles.
Before moving the machine make sure that:
-
The sliding carriage is fixed in position by the
carriage lock.
-
The motor head is completely lowered, using
the locking lever.
TO MOVE THE MACHINE:
a) Use a four-part sling, connected to the hooks in
the moving handles (photo 8).
b) The machine can easily be moved on site using
the moving wheels.
IN ORDER NOT TO COMPROMISE THE
STABILITY OF THE MACHINE, FOLLOW THE
INSTRUCTIONS BELOW CAREFULLY.
SUPPORT THE MACHINE WHILE MOVING IT.
With the machine in a working position:
a) Remove the moving wheels.
b) Loosen the rear legs locking knobs (motor
side).
c)
Remove the rear legs one at a time.
d) Put the rear side of the machine back on the
ground.
e) Repeat the operation for the front legs.
f)
Proceed to move the machine as indicated in
photo 9.
This machine must be connected to the power
supply, protected by a trip switch or a class II
insulating transformer, with the following
characteristics:
Trip Switch
In 25 A Id 30 mA
Transformer
230 V 50 Hz 4000 W
Continuous operation
N.B. To use the trip switches correctly, do not
forget to check that they are working properly
from time to time, by pushing the relevant button
on the front of the unit itself.
GB
27
9
9
6. Connecting to the power supply
CAUTION !
CAUTION !
7
7
8
8
5. Transport
CAUTION !
