Version 23.02.2021
HW: 25(V92)/(V51)
CI-VL2-N902
P
a
g
e
6
1.4.
Dip-switch settings – interface
Some settings have to be selected by the dip-switches on
the video interface.
Dip position down is ON and position up is OFF.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
See the following chapters for detailed information.
1.4.1.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs, because the disabled inputs
will be skipped while switching through the video interfaces inputs.
1.4.2.
Rear-view camera setting (dip 5)
If set to
OFF
, the interface switches to factory LVDS picture while the reverse gear is engaged
to display factory rear-view camera or factory optical park system picture.
If set to
ON
, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.3.
Monitor selection (dips 6-8)
Dips 6-8 are for monitor-specific video settings which cannot be predicted as even within the
same head-unit version, the monitor specifications may vary. It is necessary to try all
possible combinations - while a working video source is connected to the chosen input of the
interface - to see which combination gives the best picture quality and size (some may give
no picture). It is possible to first hot plug through the dip combinations, but if you do not
experience any change of picture after trying all options, retry and disconnected the 6pin
power plug of the video-box between every change of the dip setting.
Note:
Dip 1 and 4 are out of function and have to be set to
OFF
.
Dip
Function
ON (down)
OFF (up)
1
No function
set to OFF
2
CVBS AV1-input
enabled
disabled
3
CVBS AV2-input
enabled
disabled
4
No function
set to OFF
5
Rear-view cam type
after-market
factory or none
6
Monitor selection
Try all possible combinations of dips 6, 7 and 8
to find the best picture (quality and size)
7
8
