Car-Interface CI-RL2-NBT, Руководство пользователя

Страница: 7 / 20

Version 27.07.2021 HW CAM(V31)/(V71) CI-RL2-NBT
P
a
g
e
7
1.5.
Dip-switch settings of the CAN-box
All 4 dip-switches of the CAN-box have no function for normal use and
must be be set to OFF.
Dip position down is ON and position up is OFF.
Vehicle/Navigation Dip 1 Dip 2 Dip 3 Dip 4
All vehicles OFF OFF OFF OFF
2. Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1. Place of installation
The interface is installed on the backside of the factory monitor and on the backside of the
head-unit.
Deviation BMW i3:
With installation in BMW i3 the PNP cable requires an extention to the
video interface, as its head unit is located in the rear of the vehicle.
The installation place of the video Interface remains in the front of the vehicle.