Version 13.03.2015
RL-PCM3-TF
Pa
ge
5
3.
Installation
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Place of installation is on rear of the head-unit.
3.1.
Interconnecting CAN-Box, harness and factory navigation monitor
Connect female 8pin Molex connector of harness RLC-POR03 to male 8pin Molex
connector of CAN-box RLC-TV521.
Transfer female Quadlock connector of vehicle harness from rear of the head-unit
into male Quadlock connector of harness RLC-POR03.
Plug female Quadlock connector of harness RLC-POR03 into male Quadlock
connector on the rear of the head-unit.
