Version 24.01.2023
HW: CAM(V100) / (V30)
CI-RL4-UCON10
P
a
g
e
7
1.4.1.
Activating the front camera (dip 1)
If set to ON, the interface switches for 10, 15 or 20 seconds from the rear-view camera to
the front camera input after having disengaged the reverse gear, depending on the menu
adjustments. In addition, a manual switch-over to the front camera input is possible via
keypad (short press) from any image mode.
Description of the power supply output: see chapter “Power supply output for front cam”.
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.
Note:
Dip 4 is out of function and has to be set to
OFF
!
1.4.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.4.
Monitor selection (dip 6, 7, 8)
Dips 6, 7 and 8 must be set to OFF. In case of a non-optimal displayed picture with the
mentioned dip settings of dips 6, 7 and 8, we recommend to try each other possible dip
switch combination.
Note:
Dips 6-8 customize the monitor-specific video settings which sometimes even vary
within head units of the same version, caused by different monitor specifications. If the
mentioned dip positions don’t give a satisfying picture, try all possible combinations of dip6,
7 and 8 while a working video source is connected to the chosen input of the interface. One
of the combinations will show the best picture size and quality (some may give no picture). It
is possible to first hot plug through the dip combinations. If there is no change of picture
visible after trying all options, retry and disconnect the 6pin connector at the interface box
between every change of the dip setting.
