4
Setup Instructions
start Up
Before you insert the Memory card, personalise the menu.
To set the menu you can use the built-in battery, you can connect the car-charger cable and
turn on ignition or you can start the camera by connecting to your computer using the USB
cable.
•
Remove plastic film over the lens.
Memory Card (Micro SD Card)
1.
Format the Class 10 Micro SD memory card
2.
Insert the memory card by carefully inserting it into the card slot. Not enough care
or rough treatment may cause the SD card or the card slot to fail.
3.
If the device does not recognize the card, please take it out and try again.
4.
It is advisable from time to time to change the memory card.
Menu's
There are two menus, you can switch between them by pressing the menu button
"M"
once
or twice, the second press will switch from the first menu to the second menu.
First Menu - Video Menu (One press of M button)
1.
Resolution:
This camera is a Full Hi Definition camera but if you are away
from the vehicle for hours and want to use the Motion Detection function, you can
lower the resolution to 720P HD. This will give you more hours of recording on the
SD card.
2.
Loop Recording:
We recommend you set this on 5 Minutes, that means that each
video is of a 5 minute duration.
3.
WDR:
Turn WDR on,
Wide Dynamic Range
describes an attribute of
an imaging Sensor that can record greater scene details than normal,
from shadows to highlights.
4.
Motion Detection
: Should only be on when vehicle is parked and when there is a
power source.
5.
Power On Record:
Turn ON, then when power is on, video will automatically
record.
6.
Power Off Delay:
Set this to whatever duration you would like the camera to keep
recording after power if turned off.
7.
Power On Delay:
Leave this off if you want the camera to begin recording
immediately power is turned on.
8.
Record Audio:
Turn off if you wish to have a private conversation in the vehicle.
9.
Date Stamp:
Turn on so that time and date is stamped on the video.
10.
GSensor Set:
We recommend you set this at "LOW", they can sometimes be
very sensitive where heavy braking can cause the videos to be locked or saved as
read only. This will fill up the SD card and stop the Loop Recording function. If you
have this problem, turn the GSensor OFF.
